Burnham operating and Instruções de Operação

1For service and repairs to the heating plant, call your local representatives. When seeking information on the boiler, provide series and size design

10INSTALLATION INSTRUCTIONSFIGURE 6TS-71-125-DFIGURE 5TS-71-124-DNOTES: (1) When pump discharge piping exceeds 25 ft. install swing check valve at pu

11INSTALLATION INSTRUCTIONSFIGURE 8 TS-71-155-DFIGURE 7TS-71-157-C

12INSTALLATION INSTRUCTIONSFIGURE 10TS-71-127-DFIGURE 9TS-71-154-C

13 D. Turn boiler on and verify that fuel valves are closed during the burner pre-purge cycle. Turn boiler off and disconnect power. E.

146. CLEANING A WATER BOILER The oil and grease which accumulate in a new hot water boiler can be washed out in the following manner. A. Remove saf

158. BOILER WATER TREATMENT Boiler water treatment will help maximize the effectiveness and prolong the life of pressure vessels. The general object

16 1. IMPORTANT See item 10 under Operating Instruction if it becomes necessary to add water to the boiler more frequently than once a month.2. GENE

17 14. Fill the boiler to its normal waterline. 15. Add boiler water treatment compound as needed (see Section III Item 8). 16. Restore e

18 B. Steam Boilers Procedure for taking steam boilers off line at the end of heating season: Drain off boiler water until it runs cle

19 ITEM FREQUENCY ACCOMPLISHED BY REMARKS PERIODIC TESTING RECOMMENDED CHECK LISTGauges, monitors, and Daily Operator Make visual inspection a

2

20 ITEM FREQUENCY ACCOMPLISHED BY REMARKS Atomizing Air/Steam Annually Service Technician Refer to burner instructionsHigh and Low Gas Monthl

21

22

23

24LIMITED WARRANTYLIMITED WARRANTYSubject to the terms and conditions herein, Seller warrants to the original owner at the original installation site

3 design and construction for the intended use and provides adequate protection from electrical shock and harmful physical contact to pers

45. Keep boiler area clear and free from combustible  materials,gasolineandotherammablevaporsand  liquids. 6. Provide positive assur

5TABLE OF CONTENTSSECTION I General informationIntroduction ...

6SECTION I — GENERAL INFORMATION1. GENERAL INFORMATION The boiler is designed specically for forced draft ring, is available with oil, gas or co

71. BOILER PIPING Attach supply and return piping lines and insert plugs and bushings in connections as required. Supply and return piping headers a

86. FLUSHING THE BOILER All water contains some sediment which settles on the inside of the coil. Consequently, the heater should be periodically bac

9INSTALLATION INSTRUCTIONSFIGURE 4TS-71-130-DFIGURE 3TS-71-131-D